 |
| |
|
RAIL TRIGGER TUTORIAL |
|
|
STEP ONE
Begin by removing the grip frame from the gun: 2 frame screws and the A.S.A. Carefully unplug the eye wires from the board along with the solenoid wires.
|
STEP THREE
Remove trigger guard and place off to the side along with the screws.
|
STEP TWO
Then, remove both trigger guard screws, both the top and the one in the battery.
|
STEP FIVE
Remove board and both buttons.
|
STEP FOUR
Use a center punch to drive the trigger pin out. Make sure you knock the pin from right to left.
|
STEP SEVEN
Remove both micro switch screws and switch.
|
STEP SIX
Unplug wires.
 |
STEP NINE
Re-Install trigger guard.
|
STEP EIGHT
Install trigger by pushing pin in from left to right.
 |
STEP ELEVEN
Put bottom hole of micro switch through switch plate pin, screw top micro switch screw in.
|
STEP TEN
Using a .050 Allen wrench, screw switch plate screw into bottom micro switch hole.
 |
|
STEP TWELVE
Install buttons and board, plug wires in.
|
|
 |
|
